Sew-Less Summer – Fabric Covered Blinds

]

Welcome to the first post in my Sew-Less Summer Series. While most of the posts will be done by some of YOU, this first one is by little ole me. And this is the project that inspired the whole series to begin with.

The project? Fabric covered black out blinds.

Intrigued? I hope so.

I did a bunch of research online trying to find out how to do this…and ultimately I knew that I just needed to bite the bullet and try out my own combination of techniques. So the following is my attempt cover those plain, and dare I say, ugly black out blinds with the fabric of your choice.

I chose to use Heather Ross’ Far Far Away Flower Meadow Print which is done in a double gauze fabric. I decided to use this because it is adorable first off and also because I was looking for a really thin/fine fabric to use because I didn’t want to add bulk to the blind. My results are very much related to this particular fabric and I have not tried this with a quilting weight cotton. However I do think that this would work even better with quilting weight cotton. I would NOT suggest using a home dec weight fabric for this because of the bulk it would add to the blind.

Onto the directions!

Supplies:

  • Black out roller blinds precut to your window dimensions
  • Fabric cut generously to fit the dimensions of the blinds plus an inch or so extra on the long sides and a few extra inches for the bottom
  • Spray adhesive Glue
  • Craft Clue suitable for fabric and plastic
  • Fray Check
  • Thread to Match fabric (yes! I did a little sewing for this “sewless” project)

Fabric Covered Blinds

You will need a well ventilated area to work and a flat protected surface to work on. Roll out the blind and mark the length of your window with blue painters tape. (Most blinds will come longer than you need and you only need to cover what you will see)

Fabric Covered Blinds

Spray the blind with the spray adhesive according to the manufacturer’s instructions. You may want to cover the upper part of the roller blind with a rag to protect it from over spray. You don’t want that part to get sticky!

Fabric Covered Blinds

Lay the fabric over the blind, centering the fabric and leaving a 3″ or so overlap at the end of the blind. Smooth the fabric in place slowly, moving from the bottom of the blind up and out to the top. Peel off the blue painter’s tape once the fabric is in place.

Fabric Covered Blinds

Carefully turn over the blind and trim the fabric along the side edges to 1/2″.

Fabric Covered Blinds

Use Fray check along the edge of each side to prevent the fabric from fraying with use on the blind. (We do not want to do a typical double fold hem because we don’t want extra bulk on the blind.)

Fabric Covered Blinds

Allow the fray check to dry and then use the craft glue to glue the fabric onto the back side of the blind.

Fabric Covered Blinds

At the bottom of the blind, glue the fabric to itself on the sides.

fabric covered blinds

Then either use the craft glue or the spray adhesive to glue the bottom hem in place. I used the selvage edge here for a finished look but you could also use a cut edge and apply fray check just as you did with the sides. You want to make sure that the fabric comes over the bar at the bottom far enough for you to sew it down. (The bar will get in your way other wise)

fabric covered blinds

Allow the glue to dry and then take your blind to your sewing machine. Yep. You heard me. You are going to sew through the blind. Top Stitch an 1/8″ away from the edge of the blind using a large straight stitch. Also stitch along the bottom of the blind to hold the fabric in place. You may need to use a zipper foot to get close to the bar in the blind.

fabric covered blinds

And that is it! Repeat as needed for the blinds in your room. You will have a completely custom window treatment for the fraction of the cost. Plus you get to use your favorite fabrics in new ways and cover up those less than attractive black out blinds.

Install your blinds and enjoy!

fabric covered blinds

15 thoughts on “Sew-Less Summer – Fabric Covered Blinds”

  1. Thanks for showing us how to do it–I've thought about taking this on for years, but now I've no excuse not to give it a try! (well, except I'll have to go fabric shopping–darn!)

  2. This is getting creepy! I just finished my shower curtain yesterday, and we're picking up a blackout roller blind this week for the bedroom, which I hadn't considered covering in fabric but I might have to change my mind. Keep reading my mind and posting tutorials OK? 😉

  3. Your project reminds me of my gramma's house. She used those kinds of blinds and created fabric shades with scalloped edges. Oh, the fond memories! Thank you for a sweet start to my day as well as a bit of info to tuck away in the back of my brain for the future.

Leave a Reply

Shopping Cart
Scroll to Top